PRODUCT DESCRIPTION

2007 Dragon XJ450 Complete Drilling Rig
Comes fully equipped, with all pipe, collars, tools, and support equipment. Already stocked and ready to go to WORK. 

Main Carrier: 
-Dragon XJ 450 Drilling Rig mounted on a 5 axle carrier (226 total miles/9487 operating hours), equipped with 2 single front axles and 3 rear dual axles, Front tires 445/65 R22.5 20pr (L)-90% remaining, 12R 22.5 Rear tires-90% remaining, 
-Booster: NEW 2009 Peerless pin on tandem axle, self steer booster Model # J8072501-1, equipped with 275/70R 22.5 (H) tires-100% remaining 
-Drawworks: Single drum (model:JC400)-400hp, 1" lebus groove w/ADT-324H air thrust disc clutch on main drum. splash cooled closed loop cooling system, 700gl antifreeze tank
-Prime Power: Cat C-15 475hp @ 2100rpm, 9487 total hours, Teir III emission standard w/ Allison S5610HR transmission
-Auxillary Brake: Model: 22" SR Hydromatic brake w/ 528 gal. closed loop cooling system, tank mounted to carrier
-Auxilliary Equipment: Hydraulic cathead winch with 9/16" cable and tail chain. Includes 3000' of 1" XIP wire rope, (2) hydraulic tong pull-backs

Rotary Table and Drive: 
-Rotary Drive: Splash lubricated ADT-218H shaft driven clutch w/ 5 Forward and 5 Reverse, double chain drive complete with anti-reverse
-Rotary Table: 17.5" Model ZP175 Rotary table with split master bushing

Derrick/Mast: 
-Derrickt: Model JJ135/32-W, 110'.8" Two section Telescoping mast rated @ 303,000# SHL, carrier mounted. Board capacity 8000' w/ 4" drill pipe, electric drill collar & pipe mule, 4" standpipe and mud manifold, with ladder adn derrick climber, Class II Inspection and certification completed on 4/09/2010
-Crown: Box type w/ 4 cast steel sheaves. rope grooved to 1"and adapted to API 8C relative standards, equipped with handrail

Traveling System/Swivel/Kelly: 
-Block: Model: YG 150 Unitized 150ton shorty 4 sheave block/hook combination
-Swivel: Model: SL120 120ton, 5000# psi rated with wireline opening and 6 5/8" regular connection
-Kelly: 1- 38'x 5 1/4"" hex w/ Varco VRS drive bushing, 6 5/8" regular box x 4 1/2" X-hole pin (V Good condition)

Substructure: 
Model DZ137-3.7-S, Rated 330,000# GNC, 15' split telescoping w/11'7" clearance under rotary beams, Floor 16'6"x14' w/ V-Door , manual erection, stairs and handrails, winter enclosure, working floor is covered w/ 1.25" thick yellow safety traction mats, drive on substructure ramp with mud and air lines

Catwalks/Pipe Racks: 
-Catwalks: 2 (two) 27' L x 4'W 
-Pipe Racks: 3 (three) sets

Winches:
-Air hoist: Winch w/ 9/16" cable and tail chain, floor mounted

Generator House: 
-Generator/Electrical/Air Compressor: 1 - 380 KW/60Hz Marathon generator-9800 hours, Series 60 Teir III Detroit Deisel enclosed in 8'x 30' house with 1- Sullivan 25hp/200psi screw type air compressor, electrical system control panels w/ outside electrical connections, roof mounted doghouse stair/landing with handrails and stairs
-Lighting: Complete rig and interior building lighting systems, explosion proof combination florescent and mercury vapor, laid out in a standard industry configuration.

Top Dog House/Water Tank: 
-Water Tank: 250bbl water tank w/ 2- 3x4 water circulating pumps enclosed in one end and 3 station, 80gl Hickman accummulator system with plumbing and Landa power washer in the other end
-Top Doghouse: 7'x12' Top doghouse that cantilevers into water tank for mobilization, manually erected, equipped w/ benches, knowledge box and automatic driller, stairs and handrails to generator house landing

BOP: 
-Annular: 9"-3000# Regan positive close annular BOP with Hub City Iron Works 20gl single station accumulator, all mounted on 2 axle trailer 

Mud System: 
-Mud Tanks: 450 Barrel-(2) 225bbl mud tanks w/ 2- 6x8 centrifugal pumps powered by 2- 50hp Electric motors with 11" impeller, 1- 4x8 single deck shale shaker, 1- mud hopper, high pressure/low pressure jetting system, 30 bbl pre-mix pill tank
-Mud Pumps: Pump #1 WorkForce 660 (Gardner Denver PZ-8 Spec) Tri-plex pump w/ 5x6 charging pump, electric liner lube system and electric oil lube system with automatic shutdown, powered w/ Detroit Series 60 Teir III deisel engine, 1659 total hours , Allison 6061 transmission with pulsation dampner, air control remote operation, all components skidded on 1 master skid
Pump #2 WorkForce 660 (Gardner Denver PZ-8 Spec) Tri-plex pump w/ 5x6 charging pump, electric liner lube system and electric oil lube system with automatic shutdown, powered w/ Detroit Series 60 Teir III Deisel engine, 1537 total hours , Allison 6061 transmission with pulsation dampner, air control remote operation, all components skidded on 1 master skid

Changehouse/Parts Room: 
-Bottom Doghouse: Overall 8'x40', divided into 8'x20' bottom doghouse with change room that includes lockers and shelves for appliances
-Parts House: Overall 8'x40', divided into 8'x20' parts house and workshop area with work bench, grinder,vise and parts storage 

Fuel Tank: 
-Fuel Tank 1- 6500 gl 7'x16' fuel tank with filtered fuel pressure system, 120v electric

Drill Pipe: 
-(NEW) 90 jts S135-#14.4 lbs per ft, epoxy coated 4" FH, Approx. 2835',
-200 jts G105-#14.4 lbs per ft epoxy coated 4"FH connection, Inspected 08/2008, drilled one hole since inspection, Approx. 6300'

Drill Collars: 
-20 (twenty) 6 1/4" x 2 1/4" collars with slip recess 4 1/2 XH box to 4 1/2 XH pin, drilled one hole since Inspected 8/2008
-1 ea. 6 1/4"x 2 1/4 " bottom hole collar with slip recess, 4 1/2"XH box to 4 1/2" Reg. box, bored for float, drilled one hole since Inspected 8/2008